Installing the software and USB drivers

RFquad software is used to control the RF Generator output amplitude and frequency 
and monitor the power consumed by the RF Generator. 

To install the RFquad software for the RF Generator, follow these steps:
(under Windows XP or 2000 you will need Administrator access)

1.	With USB cable between the Generator and computer NOT CONNECTED, 
	insert the installation CD and run the Setup.exe program from your CD drive.
2.	Chose the desirable location and folder name for the software.  By default, 
	the folder is: C:\Program Files\MassTech\RFquad\
3.	Follow the next few dialog boxes to completion.

After the software installation process is completed, you can create a shortcut on your 
desktop to run the software from the desktop.  

To use the USB port to communicate between the RF Generator and computer, you will 
need to install the USB Driver for this communication method.

To enable USB communication with the RF Generator, follow these steps:  
(under Windows XP or 2000 you will need Administrator access)

1.	Ensure that the one end of USB cable is properly connected to the RF Generator 
	while the other end of the cable IS NOT connected to the computer.
2.	Turn ON the power of the RF Generator.
3.	Plug the USB cable into the computer.
4.	The computer should detect New Hardware Found
5.	In the Hardware Wizard dialog, answer the question: Can Windows connect 
	to Windows Update as No, not this time. Click Next button.
6.	In the next dialog, choose Install from the list of specific location (Advanced) 
	option. Click Next.
7.	In the next dialog, choose Search for the best drivers in these locations and
	Include this location in the search options. Use Browse button to open 
	USB Driver directory of the Installation CD into the search field.
8.	Answer Continue Anyway to the Windows compatibility warning message. 
	Wait till the driver installation is completed and press Finish button. 
	Wait for some time.
9.	If New Hardware Found message has appeared again, repeat steps 5-8. 
	Finally, the message Your new hardware is installed and ready to use will 
	indicate that USB driver setup is finished successfully. After that, you can 
	run RFquad software to control the RF generator.
